Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 5
• 2+16-channel and 4+16-channel mixed-signal oscilloscope (MSO) models.
An MSO lets you debug your mixed-signal designs using analog signals and
tightly correlated digital signals simultaneously. The 16 digital channels have a
1 GSa/s sample rate (1.25 GSa/s for the 1 GHz models), with a 50 MHz toggle
rate.
•8.5 inch WVGA display.
• Interleaved 2 Mpts or non-interleaved 1 Mpts MegaZoom IV memory for the
fastest waveform update rates, uncompromised. Upgradeable to
4 Mpts/2 Mpts.
• All knobs are pushable for making quick selections.
• Trigger types: edge, edge then edge, pulse width, pattern, OR, rise/fall time,
Nth edge burst, runt, setup & hold, video, and USB.
• Serial decode/trigger options for: CAN/LIN, FlexRay, I
2
C/SPI, I
2
S,
UART/RS232, and MIL-STD-1553/ARINC 429. Lister for serial decode
• Math waveforms: add, subtract, multiply, FFT, d/dt, integrate, and square root.
With the advanced math option, you get these additional math waveforms:
Ax+B, square, absolute value, common logarithm, natural logarithm,
exponential, base 10 exponential, low pass filter, high pass filter, magnify,
measurement trend, chart logic bus timing, and chart logic bus state.
• Reference waveform locations (2) for comparing with other channel or math
waveforms.
• Many built-in measurements and a measurement statistics display.
• Built-in license-enabled waveform generator with: arbitrary, sine, square,
ramp, pulse, DC, noise, sine cardinal, exponential rise, exponential fall, cardiac,
and gaussian pulse.
• USB ports make printing, saving and sharing data easy.
• Optional LAN/VGA module for connecting to a network and displaying the
screen on a different monitor.
• Optional GPIB module.
• A Quick Help system is built into the oscilloscope. Press and hold any key to
display Quick Help. Complete instructions for using the quick help system are
given in "Access the Built-In Quick Help" on page 46.
For more information about InfiniiVision oscilloscopes, see:
www.keysight.com/find/scope
To Next Page
Loading...
Need help?
General
