88 Keysight EXG and MXG X-Series Signal Generators User’s Guide
Optimizing Performance for All Models
Using the Dual Power Meter Display (with USB U2000A Series Power Sensors)
Example: Dual Power Meter Calibration
In the following example, a U2004A USB Power Sensor is connected to channel A and a N1912A P–
Series Power Meter and 8482A Power Sensor are connected to channel B and are zeroed and
calibrated, as required.
On the signal generator:
1. Setup for Step Sweep. “Using Swept Signal Mode (Configuring a Swept Output)” on page 62.
2. Connecting the Channel A power sensor: Connect USB sensor to the signal generator. The
MXG/EXG should display a message across the bottom that reads similar to:
USB TMC488 device (USB POWER SENSOR,MY47400143) connected
Figure 5-4 MXG/EXG Displays Connection to U2000 USB Power Sensor
3. Press Aux Fctn > Power Meter Measurements > Channel A Setup > Connection Settings >
Connection Type > USB Device (None) > USB POWER SENSOR (MY47400143)
4. Press Return > Zero Sensor
A diagnostic dialog box appears the initial time that a U2000 Series power sensor with a
different serial number is connected to the signal generator (refer to Figure 5-5). After the
U2000 has been recognized by the signal generator, the U2000 power sensor is saved as a
softkey in the instrument and the dialog box in Figure 5-5 won’t be displayed (press DONE, if
you see this message).
Figure 5-5 Diagnostic Dialog Box for USB Sensor
Verify RF Output power is off before continuing.
To Next Page
Loading...
Need help?
General
