U2000 Series Operating and Service Guide XVII
List of Figures
Figure 1-1 LED indicator sequence during power-up 5
Figure 1-2 Block diagram of the RF/microwave USB power sensor 8
Figure 1-3 Simplified block diagram of diode pair/attenuator/diode pair 9
Figure 1-4 Found New Hardware Wizard window 13
Figure 1-5 Found New Hardware Wizard driver installation 14
Figure 1-6 Hardware installation warning message 14
Figure 1-7 Completing hardware driver installations 15
Figure 1-8 USB device alias configuration 15
Figure 1-9 Keysight Connection Expert with a list of instrument I/O on the PC 16
Figure 1-10 Keysight Interactive IO dialog box 16
Figure 1-11 Identification of your connected power sensor displayed 17
Figure 1-12 Keysight IO Libraries Suite 19
Figure 1-13 Power Analysis Manager Instrument Properties panel 20
Figure 1-14 Calibration due date display 20
Figure 2-1 Example of trace graph display for GSM signal 23
Figure 2-2 Measurement gate 24
Figure 2-3 Auto-averaging settings 26
Figure 2-4 Select either INT or EXT from the Zero Type option 31
Figure 3-1 U2000A typical SWR (25 °C ±10 °C) 40
Figure 3-2 U2001A Typical SWR (25 °C ±10 °C) 41
Figure 3-3 U2002A Typical SWR (25 °C ±10 °C) 41
Figure 3-4 U2004A Typical SWR (25 °C ±10 °C) 42
Figure 3-5 U2000H Typical SWR (25 °C ±10 °C) 42
Figure 3-6 U2001H Typical SWR (25 °C ±10 °C) 43
Figure 3-7 U2002H Typical SWR (25 °C ±10 °C) 43
Figure 3-8 U2000B typical SWR (25 °C ±10 °C) 44
Figure 3-9 U2001B typical SWR (25 °C ±10 °C) 44
Figure 3-10 Typical power accuracy at 25 °C for U2000/1/2/4A models
1
, 2 49
Figure 3-11 Typical power accuracy at 25 °C for U2000/1B models
1
, 2 49
Figure 3-12 Typical power accuracy at 25 °C for U2000/1/2H models
,
50
Figure 3-13 Settling time with auto filter, default resolution, and a 10 dB decreasing power
step (not across the switching point) 60
To Next Page
Loading...
Need help?
General
