2 Base Matrix Configuration
154 Keysight 34934A User’s Guide
The completed bundles are shown below.
34934T-002 Terminal Block: 8x64 Jumper Configuration
This terminal block has three types of jumpers which must be connected to
configure the 8x64 matrix (matrices):
– CONFIG Jumpers: place these 2-pin jumpers identically on all four 4x2 blocks
of jumper pins located near the board’s female D-Sub connectors, as shown.
– ID Jumpers: place these 2-pin jumpers on a 2x3 block of jumper pins on the
lower right corner of the board, as shown.
– Safety Interlock Continuity Jumpers: place the supplied pre-wired
terminators or equivalent custom wiring on the two 20-pin extension headers
at the bottom of the terminal block, as shown.
left
bundle
to
terminals
to field wiring
right
bundle
“outside”
holes
“outside”
holes
“inside”
holes
To Next Page
Loading...