Keysight 34934A - Page 165

Base Matrix Configuration 2
Keysight 34934A User’s Guide 165
The following illustration shows the jumper block J7, along with the relevant
guidance provided on the board’s silk-screen for jumper placement:
Placing Row Access Jumpers on the 34934C-002 Configuration Block
The jumpers in 3x16 jumper block J8 (at lower board center) determine if row
connections can be made from the male D-Sub connector P2 (i.e. they “enable”
the row signal connection points at this D-sub).
TEND ROWS LEFT (J5), (J6)
EXTEND ROWS RIGHT (J3), (J4)
J7
J7
J7
If you plan to extend rows
left, to J5 and J6, place two
2x8 jumpers as shown at right.
J7
J7
If you plan to extend rows
right, to J3 and J4, place two
2x8 jumpers as shown at right.