2 Base Matrix Configuration
82 Keysight 34934A User’s Guide
To set the CONFIG jumpers for 4x64:
1 Place eight horizontally
positioned jumpers as
shown at right.
2 Then stack eight vertically
positioned jumpers above
the first set, as shown at
right.
This board configuration (through step 2) “extends” the four row signals either left
to connector J5 or right to connector J4, depending on the placement of jumpers
in block J7. The row signals will also be extended to male D-Sub connector P1, if
“enabled” by placement of jumpers in block J8. This provides typical row
connectivity options.
3 Optional Step: For the 4x64 base configuration, additional jumpers must be
placed to provide the following additional options for row connectivity:
– extend the row signals either left to connector J6 or right to connector J3,
depending on the placement of jumpers in block J7.
– extend the row signals to male D-Sub connector P2, if “enabled” by
placement of jumpers in block J8.
If these additional row
connectivity options are desired,
stack eight additional
vertically positioned jumpers
as shown at right.
CONFIG
CONFIG
JUMPERS
JUMPERS
J11
J13 J12
J10
J7
adjacent housings should not touch
CONFIG
CONFIG
JUMPERS
JUMPERS
J11
J13 J12
J10
J7
adjacent housings
should not touch
CONFIG
CONFIG
JUMPERS
JUMPERS
J11
J13 J12
J10
J7
To Next Page
Loading...