Keysight EDUX1052G - To Verify Bandwidth (-3 Db)

24 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes Service Guide
2 Testing Performance
To verify bandwidth (-3 dB)
This test checks the bandwidth (-3 dB) of the oscilloscope. In this test you will use
a signal generator and a power meter.
Table 6 Bandwidth (-3 dB) Test Limits
Models Test Limits
200 MHz Models All channels (-3 dB), dc to 200 MHz
100 MHz Models All channels (-3 dB), dc to 100 MHz
70 MHz Models All channels (-3 dB), dc to 70 MHz
50 MHz Models All channels (-3 dB), dc to 50 MHz
Table 7 Equipment Required to Verify Bandwidth (-3 dB)
Equipment Critical Specifications Recommended Model/Part
Signal Generator 100 kHz - 200 MHz at 200 mVrms Keysight N5181A
Power Meter 1 MHz - 200 MHz ±3% accuracy Keysight N1914A
Power Sensor 1 MHz - 200 MHz ±3% accuracy Keysight E9304A or N8482A
Power Splitter outputs differ by < 0.15 dB Keysight 11667A
Cable Type N (m) 24 inch Keysight 11500B
Adapter Type N (m) to BNC (m) Keysight 1250-0082 or
Pomona 3288 with Pomona
3533
50 Ohm Feedthrough
Termination
50
Ω BNC (f) to BNC (m) Keysight 0960-0301