Getting Started 1
Keysight N1911A and N1912A Installation Guide 15
.
These keys and connectors are associated with the measurement channels and
are located on the right-hand side of the front panel.
Key Function
The arrow keys are used to highlight measurement setups and change parameters
such as instrument state names. The user’s guide shows how these keys are used in
more detail
Press this key to check the highlighted parameter On/ Off or select the highlighted
field. Refer to the user’s guide for more information.
Press this key to access the zero and calibration menus. Refer to the user’s guide
for more information.
Press this key to when in Single Trigger mode to start and stop the acquisition of
the measurement. Refer to the user’s guide for more information.
Press these keys to enter numeric values in the pop-up fields, for example, the
offset values. To complete the entry use the softkey. Refer to the user’s guide for
more information.
To Next Page
Loading...
