EasyManuals Logo

Keysight N777 C Series Programming Guide

Keysight N777 C Series
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
Keysight N777xC Series Tunable Laser Family Programming Guide 37
Instrument Setup and Status 3
Command: :STATus0:OPERation:ENABle
Syntax: :STATus0:OPERation:ENABle<wsp><value>
Description: Sets the bits in the Operation Slot Status Enable Mask (OSSEM) for the laser module that enable the contents of the
Operation Slot Status Event Register (OSSER) to affect the OSESR.
Setting a bit in this register to 1 enables the corresponding bit in the OSSER and OSESR.
Parameters: The bit value for the OSSEM as a 16-bit unsigned integer value (0 .. +65535)
Response: none
Example: :stat0:oper:enab 128
Command: :STATus0:OPERation:ENABle?
Syntax: :STATus0:OPERation:ENABle?
Description: Returns the OSSEM of the laser module
Parameters: none
Response: The bit value for the OSSEM as a 16-bit unsigned integer value (0 .. +65535)
Example: :stat0:oper:enab? -> +128
Command: :STATus:PRESet
Syntax: :STATus:PRESet
Description: Presets all bits in all OPERation and QUEStionable status systems to 0.
Parameters: none
Response: none
Example: :stat:pres

Table of Contents

Other manuals for Keysight N777 C Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight N777 C Series and is the answer not in the manual?

Keysight N777 C Series Specifications

General IconGeneral
BrandKeysight
ModelN777 C Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals