Keysight N777 C Series - Page 73

Keysight N777xC Series Tunable Laser Family Programming Guide 73
Measurement Operations & Settings 4
Response: none
Example: :sour0:wav:swe:mode STEP
Affects: All N777xC tunable laser sources
Command: :SOURce0:WAVelength:SWEep:MODE?
Syntax: :SOURce0:WAVelength:SWEep:MODE?
Description: Returns the sweep mode.
Parameters: None
Response: STEP:
MAN:
CONT:
Stepped sweep mode
Manual sweep mode
Continuous sweep mode
Example: :sour0:wav:swe:mode? -> STEP
Affects: All N777xC tunable laser sources
Command: :SOURce0:WAVelength:SWEep:PMAX?
Syntax: :SOURce0:WAVelength:SWEep:PMAX?<wsp><start wavelength>,<stop wavelength>
Description: Returns the power to the highest permissible power for the selected wavelength sweep.
Parameters: start wavelength:
stop wavelength:
The wavelength at which the sweep starts as a float value.
The wavelength at which the sweep starts as a float value.
Response: The highest permissible power for the selected wavelength sweep as a float value.
Example: :sour0:wav:swe:pmax? 1540nm,1550nm -> +3.5500000E-004
Affects: All N777xC tunable laser sources
Command: :SOURce0:WAVelength:SWEep:REPeat
Syntax: :SOURce0:WAVelength:SWEep:REPeat<wsp><mode>
Description: Sets the repeat mode. Applies in stepped-sweep and manual sweep modes. The N7776C, N7777C and N7778C also support
TWOWay mode in continuous sweep mode.