Keysight N777 C Series Programming Guide

74 Keysight N777xC Series Tunable Laser Family Programming Guide
4 Measurement Operations & Settings
Parameters: ONEWay:
TWOWay:
Every stepped or continuous sweep cycle starts at the start wavelength of the sweep and ends at the stop
wavelength of the sweep
Every odd sweep cycle starts at the start wavelength of the sweep, and every even sweep cycle starts at the
stop wavelength of the sweep.
Set the start and stop wavelength of the sweep using :SOURce0:WAVelength:SWEep:STARt
on page 75 and :SOURce0:WAVelength:SWEep:STOP on page 76 respectively.
Response: none
Example: :sour0:wav:swe:rep twow
Affects: All N777xC tunable laser sources
Command: :SOURce0:WAVelength:SWEep:REPeat?
Syntax: :SOURce0:WAVelength:SWEep:REPeat?
Description: Returns the repeat mode.
Parameters: None
Response: ONEWay:
TWOWay:
Every stepped or continuous sweep cycle starts at the start wavelength of the sweep and ends at the
stop wavelength of the sweep
Every odd sweep cycle starts at the start wavelength of the sweep, and every even sweep cycle starts at
the stop wavelength of the sweep.
Set the start and stop wavelength of the sweep using
:SOURce0:WAVelength:SWEep:STARt on page 75 and
:SOURce0:WAVelength:SWEep:STOP on page 76 respectively.
Example: :sour0:wav:swe:rep? -> ONEW
Affects: All N777xC tunable laser sources
Command: :SOURce0:WAVelength:SWEep:SOFTtrigger
Syntax: :SOURce0:WAVelength:SWEep:SOFTtrigger
Description: Softtrigger does the same as a normal (hardware) trigger at the backplane.
Usage:
- Trigger input configuration: Start Sweep
- Start Sweep
- SoftTrigger
Parameters: None

Keysight N777 C Series Specifications

General

Brand	Keysight
Model	N777 C Series
Category	Measuring Instruments
Language	English