293
Keysight Handheld Analyzers
N99xxA User’s Guide
15 Built-in Power Meter Mode – Option 310
Built-in Power Meter (also known as Channel Power Meter) uses the SA input
connector to make quick and simple power measurements over a selectable
frequency band. A power sensor is NOT required.
In this Chapter
See Also
The following Built-in Power Meter settings are identical to the standard Power
Meter settings:
“Frequency/ Span / Step” on page 295
“Radio Standard” on page 296
“How to set Attenuation” on page 296
“Scale” on page 303
“Relative and Offset Power Measurements” on page 304
“Display Units” on page 304
“Averaging” on page 305
“Single or Continuous Measure” on page 305
To Next Page
Loading...
Need help?
General
