474 Keysight N9927-90001 User’s Guide
System Settings
Audio (Volume) Control
—Then User Preset ON
How to recall User Preset
—Press Preset.
— Then choose from the following:
— Preset (User)
The entire UserPreset.sta file is recalled. ALL modes
assume the settings that were in place when the User Preset was
saved. The active mode is the mode that was visible when the file was
saved.
— Mode Preset (User)
The settings for only the current mode are
recalled from UserPreset.sta.
Audio (Volume) Control
System volume control is a FieldFox global setting which sets speaker volume
for ALL success beeps, key press clicks, and individual features that use the
FieldFox speaker, such as SA Mode Tune and Listen.
The volume control setting remains through a FieldFox Preset. To cause your
volume control setting to remain through a FieldFox shut down, save the
setting as a Preference. Learn how in “Save and Reset Preferences” on
page 478.
How to set the FieldFox Volume Control
—Press System 7
—Then Volume
— Then use the arrows, the rotary knob, or numeric keypad to enter a
value between 0 (lowest volume) and 100 (highest volume).
— Only the instrument settings are saved to UserPreset.sta. No trace data
or calibration data is saved.
—
User Preset ON / OFF is saved as a Preference setting. Like all
preferences, this setting survives a FieldFox shut down and power ON.
Therefore, when User Preset is ON during shut down, the FieldFox will
load UserPreset.sta when it is powered ON.
—
To return to Factory Preset, select User Preset OFF. The contents of
UserPreset.sta remain stored on the FieldFox. When User Preset is OFF,
you can also set the Startup Mode preference that determines which
mode will be visible after powering ON. Learn more in “Startup Mode”
on page 481.
.
To Next Page
Loading...
