Keysight U1272A - Capturing Maximum and Minimum Values (Maxmin)

3Multimeter Features
Capturing Maximum and Minimum Values (MaxMin)
112 U1271A/U1272A User’s Guide
Capturing Maximum and Minimum Values (MaxMin)
The MaxMin operation stores the maximum, minimum, and
average input values during a series of measurements.
When the input goes below the recorded minimum value or
above the recorded maximum value, the multimeter beeps
and records the new value. The elapsed time since the
recording session was started is stored and shown on the
display at the same time. The multimeter also calculates an
average of all readings taken since the MaxMin mode was
activated.
From the multimeter’s display, you can view the following
statistical data for any set of readings:
• Max: highest reading since the MaxMin function was
enabled
• Min: lowest reading since the MaxMin function was
enabled
• Avg: average or mean of all readings since the MaxMin
function was enabled
• MaxMinAvg: present reading (actual input signal value)
1 Press to enable the MaxMin operation.
2 Press again to cycle through the Max, Min, Avg, or
present (MaxMinAvg) input values.
NOTE
This function is applicable to all measurements except for continuity and
diode tests.
P
e
a
k
M
a
x
M
i
n
P
e
a
k
M
a
x
M
i
n