Keysight U1272A - Using Qik-V for Voltage Measurements (U1271 A Only); Figure 2-12 Qik-V Display

2 Making Measurements
Using Qik-V for Voltage Measurements (U1271A only)
70 U1271A/U1272A User’s Guide
Using Qik-V for Voltage Measurements (U1271A only)
Use the Qik- V function to help you check for the presence of
either or both AC and DC voltages before you set a precise
range for a more accurate reading.
1 To quickly identify the measured signal type, rotate the
multimeter’s rotary switch to .
2 Probe the test points and read the display. The AC voltage
measurement is shown in the primary display and the DC
voltage measurement is shown in the secondary display.
Press to exchange the ACAC and DC voltage
indication on the primary and secondary displays.
Figure 2-12 Qik-V display
Once the signal type is identified (AC, DC, or AC+DC
voltage), select the appropriate voltage measurement function
by turning the rotary switch to an appropriate position and
function (AC, DC, or AC+DC) for a more accurate reading.
Qik-V
Exit
Dual