Service and Maintenance 2
Keysight U1281A/U1282A Service Guide 63
4 Lift the inner rubber cover to access the fuse
compartment.
5 Remove the defective fuse gently by prying
one end of the fuse with a flathead
screwdriver and removing it out of the fuse
bracket.
6 Replace a new fuse of the same size and
rating at the center of the fuse holder.
7 Ensure that the inner rubber cover is
positioned properly.
8 Close the inner rubber cover of the fuse
compartment.
9 Place the fuse cover back in its original
position and tighten the screws.
10 Finally fit the orange rubber holster back on
the multimeter.
To Next Page
Loading...
