Appendix B: Worksheets
210 P/N 3102351-EN • REV 005 • ISS 28DEC18
Device settings worksheet
The device settings worksheet is used to document the configuration and settings for each of
the devices on the system.
Note: For default settings, see “Factory default settings” on page 42.
Type of device ☐ Photo detector ☐ Photo/heat detector ☐ Heat detector
☐ Duct detector ☐ Ion detector ☐ Relay module
☐ NAC module ☐ Input module
Device address
Serial number
Label Line 1
Label Line 2
Zone
Correlation groups
Day sensitivity ☐ Normal ☐ Least ☐ Less ☐ More ☐ Most
Night sensitivity ☐ Normal ☐ Least ☐ Less ☐ More ☐ Most
Day prealarm % (Off, 50, 55, 60, 65, 70, 75, 80, 90)
Night prealarm % (Off, 50, 55, 60, 65, 70, 75, 80, 90)
Base type ☐ Standard ☐ Relay ☐ Isolator ☐ Sounder
Base follow ☐ Alarm ☐ Alarm + verify ☐ Alarm + prealarm
☐ Head ☐ None ☐ Riser (sounder bases only)
Follow CO ☐ Yes ☐ No
Type
☐ Smoke ☐ Duct alarm ☐ Remote reset
☐ Smoke verified ☐ Duct supervisory ☐ Remote drill
☐ Smoke heat ☐ Monitor ☐ Remote signal silence
☐ Smoke CO ☐ Supervisory (latching) ☐ Remote AC fail
☐ Heat alarm ☐ Supervisory (nonlatching) ☐ Remote test station
☐ Heat alarm RoR ☐ Relay (nonsilenceable) ☐ Continuous (nonsilencble)
☐ Pull station ☐ Relay (silenceable) ☐ Continuous (silenceable)
☐ Waterflow ☐ Genesis (silenceable) ☐ Alarm
☐ Waterflow (retard) ☐ Genesis (nonsilenceable)
To Next Page
