Chapter 2: Front panel programming
66 P/N 3102351-EN • REV 005 • ISS 28DEC18
• If the system history log is filled with event records resulting from a faulty device, problem,
or situation, you can clear the history log after the problem is addressed.
Note: When the history log is full, the oldest event is deleted when a new event is added.
To clear the event history log:
1. Press the Menu button and choose Program.
2. Choose Clear History.
3. Enter a level two password.
4. Select Yes to clear history or No to leave history unchanged.
5. Press Enter.
6. Press the Menu button to exit menu mode, or continue programming.
Updating the firmware
The Firmware Update Utility (FUU) lets you install new firmware in the main panel or loop
interface module. It also lets you retrieve the current firmware version in your panel. Refer to
the Firmware Update Utility release notes to verify which panel versions can be updated using
the FUU. Refer to the FUU help for instructions on how to use the FUU.
Updating the loop interface module firmware is a three-step process.
1. Obtain the loop interface module firmware from the appropriate website, and then load it
into the FUU software.
2. Download the loop interface module firmware to the panel main board using the FUU
software.
3. Write the loop interface module firmware from the panel main board to the SLC card using
front panel programming.
To Next Page
Loading...
Need help?
General
