Kikkoman Lumitester PD-30 - Page 10

17 18
Specify groups and load the
Level value setting.
Specify groups and load the
Level value setting.
Specify groups and load the Level values.
Abort PLAN creation.
Load all Level values from
the PD-30.
Click groups to select.
Selected groups are
highlighted.
Abort PLAN creation.
Paste after the data is
created.
⑥After clicking the MODE cell, click the write button to write the PLAN to the
PD-30.
The [PLAN No. 001: kibio - Inspect00] plan was input to the PD-30.
<Select all to set PLAN>
⑦When you click the option button to select all on aforementioned ⑤, the level
set of all the MODE numbers are loaded so that a test plan with the combination
of arbitrarily selected MODE numbers can be set as shown below.
⑧Select an appropriate MODE number to create a PLAN (test plan).
⑨Click the "Arrange" button. The selected MODE numbers are arranged in
ascending order.
⑩To arrange the MODE numbers in measurement order, click to highlight the line
of the MODE number to move, and then click "Up" or "Down" to move it.
⑪When you click the "Write" button, only the MODE number with the check box
selected is input to the PD-30 as the test plan of its PLAN name.
Up to 100 plans can be input to the PD-30 according to the procedure above.
Reference: Relationship between the level set and plan
A plan is created based on up to 300 level sets that have been arbitrarily selected
from the level sets (up to 400 sets: MODE001 to 400) in which objects etc. have
been input.
The measurement orders (STEP) can be arbitrarily replaced according to the
arrangement of the objects at the site to create a plan.
Click the MODE (uppermost) cell to select all MODE numbers.
Paste after the data is created.
Arrange the selected
MODE numbers in
ascending order.
Move the selected
MODE number one
cell upward.
Move the selected
MODE number one
cell downward.
Select the checkboxes for
the MODE numbers to select.
MODE 000
MODE 001
MODE 002
MODE 003
MODE 004
MODE 005
MODE 006
r
r
r
MODE 400
Select MODE number.
MODE 001
MODE 003
MODE 005
MODE 006
r
r
r
Arrange
MODE 005
MODE 006
MODE 003
MODE 001
r
r
r
STEP 001
STEP 002
STEP 003
STEP 004
r
r
r
｝
MODE 000 cannot be selected.
Set the level before
creating a PLAN.
"STEP" here refers to
the sequence of PLAN
measurement.
Multiple selection of the same
MODE number is not possible.
Instead, specify the same Level
values for dierent MODE numbers.
Setting the MODE numbers
to the same group make
PLAN creation easier.
Up to 300 MODE numbers can be selected.