Kikkoman Lumitester PD-30 - Software Operation Guide; Start-up and Exit Software

⑫Installation is completed. Click “Close”.
⑩Click “Next”.
⑪The installation is loading.
9 10
Be sure to read the “Instructions for Use” (Section 1.1 on Page 1) before connecting
the PD-30 with a PC.
3 How to operate the Software
Caution
Plug the provided USB
cable into the PD-30.
Connect the cable to the PC.
rInsert the batteries before connecting the PD-30 with a PC.
Without the batteries, the PD-30 may not start up.
rConnect the PD-30 with the PC by using the provided USB cable.
rWhen connecting the PD-30 to the PC, use the USB port in which the USB
driver has been installed.
It is necessary to install the USB driver for each USB port.
rThe PD-30 may not be recognized occasionally after being connected to a USB
port. In this case, disconnect the USB cable and then reconnect it.
rIf the PD-30 cannot be connected to the PC using the USB port in which the
USB driver has been installed, change the USB port and install the USB driver,
and then connect the PD-30 to the PC.
3.1 Start-up and Exit the Software
<How to start up the software>
①If you are using other software programs, quit all of them.
If you are using other USB devices, disconnect all of them.
②Connect the PD-30 to the USB port in which the USB driver has been installed.
rOnly one PD-30 is allowed to connect to the PC.