Kikkoman Lumitester PD-30 - PLAN Measurement Procedure; Memory Data Management; Loading Memory Data

19 20
②
③
①Press MODE key for two seconds or more to select PLAN measurement.
3.3.3 PLAN Measurement Procedure
ENTER
Use the reagent of dedicated disposable type. Follow the instruction manual for
the reagent.
⑩
Close the measurement
chamber cover.
⑨
Remove the reagent
from the measurement
chamber.
⑧
Open the measurement
chamber cover as reagent
warning is displayed.
④
Open the
measurement
chamber cover.
Repeat from ③ to ⑩ for the next measurement.
Press MODE key for two seconds or more to end PLAN measurement.
⑤
Place the reagent in the
measurement chamber.
⑥
Close the measurement
chamber cover.
⑦
Press ENTER key.
Measurement result is
displayed after countdown.
PLAN"001"
Kibio - Inspect00
Object
Object A
3000
1500
PLAN002/002
Kibio - Inspect01
Object
Object A
9999
5000
PLAN Measurement MODE Measurement
PLAN001/001
#0001
Object
Object A
RLU
3000
1500
MODE 001
#0001
Object
Object A
RLU
3000
1500
Caution
Press MODE key. Then PLAN number blinks.
Press keys to select a PLAN number, and press ENTER key to conrm.
Press 
keys to select
a STEP.
rPrevious measured data can be checked by selecting a STEP.
If two or more measurements are performed on the same STEP, only the latest
measured data can be checked. However, all the measured data are recorded.
3.4 Memory Data Management
There are two le format types to save and print data by loading measured data of
the PD-30; the CSV format that is easy to process with the spread sheet software, and
the JPEG format that cannot be falsied.
Specify conditions to extract specic portion of the loaded memory data for display
or graph representation.
All the PD-30 measured data can also be deleted.
3.4.1 Loading Memory Data
①Click the "Load" button.
②Specify the load method and click the "OK" button.
rThe loaded measured data is displayed on the screen. adding or modifying
the data is not allowed to prevent falsication of data.
Load the Memory Data from PD-30.
Print out the Load Data.
Summarize the measured data.
Display the measurement method.
Display the model.
Display the serial number of PD-30.
Save the Load Data in CSV format.
Save the Load Data in JPEG format.
Enter a number directly.
Enter a date directly, or click the date
and up/down button.
Load all the memory data.
Load the memory data of the specied
PLAN number.
Load the memory data of the specied
date.
Load the memory data of the specied
data number.
Clear all of the PD-30 Memory data.