Kikkoman Lumitester PD-30 - AX+B Measurement

25 26
Line GraphDisplays the average measured values at each object in chronological order.
Circular Chart The percentage for the rank for the extracted measured data is displayed.
Extraction conditions are displayed.
The percentage for the rank for the extracted measured data is displayed.
Extraction conditions are displayed. Display the average measured values at each object in chronological order.
Print the graph.
Copy the graph on the clip board.
Close the graph.
Print the graph.
Copy the graph on the clip board.
Close the graph.
Groups are displayed on the right side
of the Object.
One group marked with an arrow
continues until the next group.
Enclosing the area with the left mouse
button pressed enlarges its area.
Information on the measured data before Summarizing and
information on the measured data after Summarizing is displayed.
Information on the
measured data will be
displayed when the pointer
is moved near a
highlighted area.
Information on the measured data before Summarizing and information on the measured data after Summarizing is displayed.
r A circular chart cannot be created since no rank is determined if AX+B measurement is selected.
3.5 AX+B Measurement
AX+B measurement is not normally used for swab test.
Measured values are converted by the primary expression, and displayed.
The unit for the values can be selected as required.
Conversion Expression : Y = AX + B X : Relative Light Unit (RLU)
Y : Displayed Value
A : Coecient
The initial value is 1 (1.00E+00).
B : Coecient
The initial value is 0 (0.00E+00).
AX + B Conversion Example
Relative Light Unit (RLU)
Gradient A
B
Ex) ATP Concentration (mol)
rTemperature compensation is OFF if AX+B measurement is selected.
rWhen performing MODE 000 measurement by selecting AX+B measurement,
the unit is RLU and temperature compensation is OFF.
(When performing MODE 000 measurement with PLAN measurement
available, follow the temperature compensation setting.)