Kikkoman Lumitester PD-30 - AX+B Measurement Settings; AX+B Measurement Procedure

27 28
3.5.1 AX+B Measurement Setting
Measured values are converted by the primary expression, and displayed.
The unit for the values can be selected as required.
rSelecting RLU returns the setting returns to the previous setting.
rSpecify the mantissa and exponent portions of Coecient A and B to values
within 3 and 2 digits respectively.
Caution
All the measured data of the PD-30 will be deleted when the measurement method is written.
After Memory Data is deleted the memory data cannot be recovered.
If you need to save the measured data, write and save the measured data. Refer
"3.4 Memory Data Management" (→P20).
Load the unit from the PD-30.
Set the unit to the PD-30.
Load the measurement method from the PD-30.
Write the measurement method to the PD-30.
Conrm the coecients of the PD-30.
Select AX+B Measurement in the drop-down list.
Selecting RLU returns the setting returns to the
previous setting.
Select the unit in the
drop-down list.
Enter value directly into the cell.
Load the coecients from the PD-30.
Write the coecients to the PD-30.
Enter an initial value for a coecient.
Exit the coecient check.
RLU
pg
mol
cfu
ug
ppm
No unit
Unit list
pg/l
mol/l
cfu/ml
ug/l
3.5.2 AX+B Measurement Procedure
AX+B measurement can be switched to MODE 000 measurement. On MODE 000
measurement, RLU is displayed and temperature compensation is OFF.
②
①Press MODE key for two seconds or more to select AX+B measurement.
Use only the dedicated reagent and thoroughly read the instruction manual
provided with the reagent.
⑨
Close the
measurement
chamber cover.
⑧
Remove the reagent
from the measurement
chamber.
⑦
Open the measurement
chamber cover as
reagent warning is
displayed.
③
Open the
measurement
chamber cover.
Repeat from ② to ⑨
for the next measurement.
④
Place the reagent in the
measurement chamber.
⑤
Close the measurement
chamber cover.
⑥
Press ENTER key.
Measurement result is
displayed after
countdown.
AX+B
#0001 RLU

AX+B Measurement MODE Measurement
AX+B
#0001 RLU

MODE001
#0001 RLU
Caution
ENTER