1.1 Instructions for Use
■This software is designed to retrieve data from Lumitester PD-30 (hereinafter called
PD-30) to the PC, and to send various measurement conditions from the computer to
PD-30.
This software does not apply to Lumitester PD-20, PD-10, and C-110.
■Do not start up the CD-ROM with non CD-ROM disc drive.
■Insert the batteries before connecting the PD-30 with a PC. Without the batteries, the
PD-30 may not start up.
■Read the Instruction Manuals of your PC, before installing this software.
■Disconnect the PD-30 from the PC before starting up or shutting down the operating
system. If you start-up, shut down, or restart your PC with the PD-30, the operating
system may not start-up or shut down properly, or the PD-30 may not be recognized
correctly.
■Use the USB cable provided for the instrument.
Since polarities may dier between USB cables, using a USB cable other than the
provided one may cause the malfunction of the PD-30.
■This software is designed to be used alone. Please note that if you use this software in
conjunction with other applications, we cannot guarantee proper operation.
■Do not disconnect the USB cable while data is being load or written. In this case, it
may result in malfunction or data corruption.
■Connect the PD-30 directly to the USB port of the PC. Using a USB hub may cause
incorrect operation.
■When connecting the PD-30 to the PC, use the USB port in which the USB driver has
been installed. It is necessary to install the USB driver for each USB port.
The PD-30 may not be recognized occasionally after being connected to a USB port.
In this case, disconnect the USB cable and then reconnect it.
1.2 Software Requirements
■Please visit our website for the latest information.
http://biochemifa.kikkoman.co.jp/e/
◇PC with the following requirements:
①1.0 GHz Pentium class processor
②256 MB RAM or higher
③500 MB or more free disc space
④CD-ROM drive that can read CD-ROM discs
⑤PC with a USB port
⑥Windows Vista (32bit/64bit), Windows 7(32bit/64bit), or Windows 8(32bit/64bit)
installed
1 2
1 Read This First
2 How to install the Software
2.1 Before Installation
Two operations are required for installation; installing the driver and the control
software. These two operations should be performed consecutively without
interruption. After the operations, the following items will be installed.
①USB driver for connecting to the Lumitester PD-30
②Lumitester PD-30 Control Software
③Shortcut to our website
④Uninstall software
1.3 Description of functions
■The software can load the Date/Time information of the internal clock of the PD-30 or
write the Setting Date/Time to the PD-30.
(See section 3.2.1 on Page 12, or 3.2.2 on Page 13.)
■Plan measurement can be set.
(See section 3.3 on Page 14.)
■Levels can be set.
(See section 3.3.1 on Page 14.)
■Measured data of the PD-30 can be retrieved to the PC and various measurement
conditions can be set to the PD-30 using the PC.
(See section 3.4 on Page 20.)
To Next Page
Loading...