2.2 Installation Procedure
The steps to install the Control Software are described below with an example of
Windows 7.
2.2.1 Install the USB Driver
Install two USB drivers to connect the PD-30 to the PC.
①Shut down the PC if it is running.
②If there are any devices connected to the USB ports of the PC, remove them.
③Start up the PC. Exit any software programs that are automatically launched.
④Connect the PD-30 with the PC by using the provided USB cable.
The window shown below opens and installation starts automatically.
If the installation is complete, go to "2.2.2 Installing Control Software" (→P7)".
If the installation is not complete, go to ⑤.
⑤Click "Start" button and then click
"Control Panel". Clicking Device Manager
on the window opens the window as
shown below.
⑥The device name with the "!" mark is
displayed on Device Manager. Place the
cursor on the device name and
right-click "Update Driver Software".
⑦The screen to update the driver software is displayed.
Click "Browse my computer for driver software".
⑧Insert the provided CD-ROM into the CD-ROM drive of the PC.
From "Browse" button, select the "USB Drivers" folder in the CD-ROM, and then
click "Next" button.
3 4
To Next Page
Loading...