2
SETUP
TOS8870A
Chapter 1 SETUP
This chapter describes unpacking and general preliminary notes and precautions.
1.1 Checking for Shipping Damages and
Accessories
■
Unpacking
The Tester should be checking upon receipt for damage that might have occurred during transporta-
tion. Also check that all accessories have been provided.
Should the Tester be damaged or accessory missing, notify your Kikusui agent/distributor.
■
Packing
• When transporting the Tester, be sure to use the original packing materials. If they
are missing, contact your Kikusui agent/distributor.
• When packing the Tester, remove the power cord and all other connection cables.
1.2 Precautions for Installation
Be sure to observe the following precautions when installing the unit.
■
Do not use the unit in a flammable atmosphere.
To prevent explosion or fire, do not use the unit near alcohol or thinner, or in an atmosphere con-
taining such vapors.
■
Avoid locations where the unit is exposed to high temperature or direct
sunshine.
Do not locate the unit near a heater or in areas subject to drastic temperature changes.
Operation temperature range: 0 ˚C to 40 ˚C
Storage temperature range: -20 ˚C to 70 ˚C
■
Avoid locations of high humidity.
Do not locate the unit in high-humidity locations, i.e., near a boiler, humidifier, water supply, etc.
Operation humidity range: 20 % to 80 % RH (without condensation)
Storage humidity range: 80 % RH or less (without condensation)
Dew condensation may take place even in the operation humidity range. In such a case, do not use
the unit until the dew dries up completely.
Accessories
Item Parts No. Q'ty Check
Power cord 85-AA-0003 1
TL01-TOS High Voltage Test Leadwires
(Approx.1.5m)
KA-0607-02 1
“DANGER High-Voltage” sticker A8-210-202 1
Operation Manual Z1-002-472 1
注意
CAUTION
To Next Page
Loading...
Need help?
General
