Kimo DBM610 - 5.5.3. Point;Point Automatic Average; 5.6. Autozero Function; 5.7. Hold Measurement Function

This function allows the calculation of the average between different measurement points selected by the user.
First, select "Pt/Pt average", the device displays measurement screen.
➢ Press OK to validate the 1
st
point.
The device displays measured values and the number of measurement points.
➢ Press OK to add measurement points.
➢ Press "Moy/Avg" button to get to screen results when the required number measurement points has been
reached.
➢ Press up and down arrows to get to results of different parameters.
➢ Press "Save" to save dataset or Esc to cancel and back to measurement screen.
5.5.3. Point/point automatic average
This function allows the calculation of average value of different measurement points which are calculated on a given
duration. It is necessary to give the duration while each point will be calculated.
First, select "Auto Pt/Pt average", the device displays measurement screen.
➢ Press OK to validate the 1
st
point.
➢ Enter the duration in minute and second with arrows then press OK.
➢ Press OK to launch the measurement of the 1
st
point.
The device displays measurements and the remaining measurement duration.
➢ Press OK to add measurement points.
➢ Press "Moy/Avg" button to get to screen results when the required number measurement points has been reached.
➢ Press up and down arrows to get to results of different parameters.
➢ Press "Save" to save dataset or Esc to cancel and back to measurement screen.
5.6. Perform an autozero
The autozero allows to offset from time to time any drift of the sensitive element during time by a manual adjustment of the
zero. The autozero is made automatically when the solenoid valve is activated.
➢ Press "Zero" during measurement.
5.7. Hold the measurement
During the measurement, the “Hold” function key of the device allows to fix the measurement:
➢ Press the “Hold” function key.
The current measurement is fixed. The “HOLD” indication is displayed on the top of the screen.
➢ To fix a second measurement value, press again the “Hold” function key.
The device displays both of the fixed values: on the right the first value and on the left the second value.
➢ Press “Hold” to restore the display of the first value only.
➢ Press “Esc” to quit the “Hold” mode.
The device displays the current measured values.
Using DBM610 in micromanometer mode 17