Kinematica POLYTRON PT 1300 D - Residual Dangers

OI PT 1300 D English / Edition 3.0 / 23.10.2009
Page 10 of 37
2.2.6 GENERAL SAFETY RULES
Observe the following general safety rules:
 follow these operating instructions,
 in addition, observe the legal obligations and requirements for accident prevention
and environmental protection of the country in which you operate the equipment,
 do not make any modifications to the equipment without the written authorisation of
the manufacturer,
 only original replacement parts may be used for repairs,
 before any service work on the equipment, it must be ensured that the electrical
supply is switched off,
 after any service, maintenance or repair work has been carried out on the
system/equipment, it must be given a test run by the service technician.
 depending on the place at which it is installed, circumstances may require that
hearing protection is worn when remaining in the vicinity of the equipment for long
periods.
2.3 RESIDUAL DANGERS
When the system/equipment is used in accordance with rules and regulations, residual
dangers are minimal.
Residual danger
Countermeasures
Tripping over feed or
return lines
These should be laid appropriately.
Breakage of glass
containers
Wear protective clothing
(goggles etc.).
Spitting of the product
Hearing loss due to loud
noise.
According to the application
ear protection must be used.
Tilting of the device
Use stable, non-slip base
IN EVERY CASE THE ELECTRICAL INSTALLATION HAS
TO BE DONE BY TECHNICIAN!