OI PT 1300 D English / Edition 3.0 / 23.10.2009
4 INSTALLATION
4.1 UNPACK
Open the dispatch box and check that the contents agrees with the delivery note.
CHECK ALL PARTS FOR POSSIBLE TRANSPORT
DAMAGE. INFORM US OR YOUR DEALER IMMEDIATELY
ABOUT ANY DISAGREEMENT OR FAULT. IF POSSIBLE
SEND US DIGITAL PHOTOS BY EMAIL TO
LABORATORY@KINEMATICA.CH
4.2 COUPLING/DECOUPLING OF THE HOMOGENIZING AGGREGATE
All POLYTRON
PT 1300 D handheld units are equipped with quick-coupling.
Dispersing aggregates with diameters of 3, 5, 7 and 12 mm are available for the
PT 1300 D drive unit. All aggregates are connected to the drive in exactly the same
manner.
For assembly, while at a standstill, the coupling ring is pushed in the direction of the drive
and the coupling part of the aggregate is pushed completely into that of the drive. The
coupling ring snaps forwards again if the connection has been made properly (see the
enclosed assembly sketch).
BEFORE STARTING WORK, MAKE SURE THAT THE
AGGREGATE IS CONNECTED PROPERLY WITH THE
DRIVE. AN INCORRECT CONNECTION CAN DAMAGE THE
COUPLING PARTS OF THE DRIVE OR THE
HOMOGENIZING VESSEL.
To Next Page
Loading...