Kinematica POLYTRON PT 1300 D - Trouble Shooting

OI PT 1300 D English / Edition 3.0 / 23.10.2009
Page 24 of 37
6 TROUBLE SHOOTING
PROBLEM
REASON
CORRECTIVE MEASURES
Unusual noises
Damaged drive
bearings
Change ball bearings. Trace & replace
defective parts (shaft, bearings)
Damaged aggregate
ball bearings /sleeves
Change ball bearings / sleeves
Rotor/stator
interference
Trace and replace defective parts (shaft,
bearings)
Drive stops
Inadequate ventilation
Check if ventilation slots are clear. Cool
down the device & restart
Thermal overload with
the message “HO”
Check manner of use & ventilation. Cool
down the device & restart.
Error message “HAL”
Motor Hall sensors are defective. Contact
authorised KINEMATICA service centre
or directly to KINEMATICA AG
Drive is blocked with
error message “BLC”
Check the aggregate for solid particles
which may be blocking the rotor, remove
the particles, turn off the drive and restart
operation. If the motor is defective contact
authorised KINEMATICA service centre
or directly to KINEMATICA AG
Error message “SUP”
The internal Voltage is outer range.
Contact authorised KINEMATICA service
centre or directly to KINEMATICA AG
Vibrations
Bent shaft
Replace shaft
Worn bearing(s)
Replace bearing(s)
Defective coupling
Trace and replace defective parts
Drive does not start
Defective internal
control
Contact authorised KINEMATICA service
centre or directly to KINEMATICA AG
Drive is blocked with
error message “BLC”
Check the aggregate for solid particles
which may be blocking the rotor, remove
the particles, turn off the drive and restart
operation.
Main switch is ON
but system is not
active
Power supply not
connected
Check that supply cables are well
plugged.