Kinematica POLYTRON PT 1300 D - Maintenace; Maintenace of the Supply and Control Unit; Maintenace of the Control and Operating Module; Maintenace of the Polytron  -Aggregates

OI PT 1300 D English / Edition 3.0 / 23.10.2009
Page 22 of 37
5 MAINTENACE
Your POLYTRON

unit is designed for ease servicing. Nevertheless, it is essential to
inspect your equipment carefully and to clean it thoroughly. Drawings of the separate
components are to be found in the appendix.
THE EQUIPMENT MUST BE DIS-
CONNECTED FROM THE ELECTRICAL
SUPPLY:
 DURING ANY WORK ON THE
EQUIPMENT, IN ORDER TO AVOID ANY
PERSONAL INJURY OR OTHER DAMAGE
 WHEN CHANGING OR REMOVING THE
DISPERSING AGGREGATE
5.1 MAINTENACE OF THE SUPPLY AND CONTROL UNIT
The supply and control module does not require any special maintenance. There are also
no parts that need or can be serviced or replaced by the operator. In the case of a
malfunction, please contact KINEMATICA AG or your supplier.
5.2 MAINTENACE OF THE CONTROL AND OPERATING MODULE
The control and operating module also does not require any special maintenance. There
are no parts that need or can be serviced or replaced by the operator. In the case of a
malfunction, please contact KINEMATICA AG or your supplier.
5.3 MAINTENACE OF THE POLYTRON

-AGGREGATES
POLYTRON

- aggregates are precision instruments. Inspections and maintenance at
regular intervals ensure years of proper functioning.
All POLYTRON

dispersing aggregates for PT 1300 D are EasyClean models. They can
be autoclaved as complete units and do not have to be disassembled for this. If
disassembly is necessary for special cleaning or to replace the slide bearings, proceed
according to the following instructions. Only the slide bearing has to be controlled
alternatively replaced from time to time.