THE DEVICE MAY ONLY BE OPENED BY AUTHORISED
KINEMATICA SERVICE STATIONS.
Ensure that enough free space is available at the backside of device, so
that effective airflow and cooling is assured. Insufficient cooling may
lead to a decrease of power output.
The device has to be placed in a manner that dirt or fluids cannot
penetrate through the ventilation slots at backside of the drive.
Before changing any dispersing aggregate, the line cord has to be
plugged out
POLYTRON
dispersion aggregates may not be operated dry – the
lower sleeve bearing is cooled and lubricated by the medium being
processed. Running dry will destroy the sleeve bearing.
The dispersing aggregates should be cleaned after every operation.
Never pull the coupling during operation – the aggregate could fall out
of the coupling.
Never place the handheld horizontally or vertically with engaged
aggregate. By non-use of the handheld always provided in the recess at
the base station. Fluid is running in the motor and the life of the engine
is greatly reduced.
The handheld of version 2 is not interchangeable with the new base
station.
The handheld of version 3 is not interchangeable with the old base
station.
When the line cord is plugged, never touch the saw teeth of the
aggregate – danger of injuries due to rotating shafts and blades
KINEMATICA AG products comply with all the usual CE directives,
carry the CE marking and are delivered with a corresponding
declaration of conformity.
To Next Page
Loading...