To enable the reversing function, please install the rear camera near the license
plate and connect the red wire of the rear camera extension cable to the positive
lead of the vehicle's reversing lamp.
Note:
➀ The rear camera is not waterproof. Please protect it from water and rain.
➁ When connecting the rear camera with the extension cable, please refer to the
details below.
➂ Please clean the area to ensure the adhesive quality before installing the rear
camera.
➃ Please clean the rear windshield regularly to ensure the image quality if you
choose to install the rear camera on the rear windshield.
➄ If you choose to install it near the license plate, you can use adhesive stickers
or screws for fixing.
➅ Please use the original extension cable and rear camera. If you replace the rear
camera with product of other brands, the effect may be affected and the
machine may be damaged.
➆ Check the interface, the connecting wire and the rear camera interface, and
make sure they are plugged in tightly.
➇ Please plug in the rear camera when the camera is turned off. Do not
frequently hot-plug the interface in case any damage is caused to the camera.
For more details, please visit the link attached to watch the installation video:
https://www.youtube.com/watch?v=CZYaV5Dh4ok.
Reversing light
Reversing light positive pole
Rear camera connector
Rear camera
To Next Page
Loading...
