Kingtel KT52IP - LAN Config

To Next Page

To Previous Page

8.3.2.2 LAN Config

Field Name

Explanation

IP Address

LAN static IP.

Subnet Mask

LAN Subnet Mask.

DHCP Service

Activate DHCP server for LAN port. The phone must be rebooted

for the DHCP server setting to take effect.

NAT

Enable NAT operation

Port Mirror

Port Mirror can only be activated in bridge mode. If activated, the

data stream from the WAN port is copied to the LAN port of the

phone.

Enable Bridge Mode

If Bridge Mode is activated, the phone will not provide an IP address

for the LAN port. Instead, the LAN and WAN will be part of the

same network. If this is activated, clicking Apply, will cause the

phone will reboot.

Note: When LAN IP or bridge mode status is changed, the system will reboot! If bridge

mode is chosen, static LAN configuration will be disabled automatically.

8.3.2.3 Qos & VLAN Config

The phone supports 802.1Q/P protocol and DiffServ configuration. Use of a Virtual LAN

(VLAN) allows voice and data traffic to be separated.