Display LDAP contact’s mobile phone number
Display LDAP contact’s ohter number
Allow display LDAP contact name or not
This feature allows a call to be initiated by a computer. To place a call, enter the number in
the Dial Number box, select the line in the Line Selection box and press the Dial button. To
end the call, press the Hangup button.
This feature allows you to make some kind of broadcast call to people who are in multicast
group. You can configure a multicast key on the phone, which allows you to send a Real Time
Transport Protocol (RTP) stream to the pre-configured multicast address(es) without
involving SIP signaling. You can also configure the phone to receive an RTP stream from
pre-configured multicast listening address(es) without involving SIP signaling. You can
specify up to 10 multicast listening addresses.
To Next Page
Loading...