Kingtex FT Series User Manual

針板孔
承座
6-2 針棒高度及針落點(圖 C,D,E )
鎖緊螺絲
ADJUSTING THE HEIGHT OF NEEDLE BAR AND NEEDLE DROP POINT
C. 當結線鉤與左針交會時，鉤尖在針孔上方約 0.5-1mm 為針棒高度設定標準位置。
WHEN THE TIP OF LOOPER COMES TO THE CENTER OF LEFT NEEDLE,THE LOOPER SHOULD
POSITION ABOVE THE UPPER END OF NEEDLE EYE BY 0.5-1.0 mm AS THIS IS THE STANDARD
POSITION FOR NEEDLE BAR.
D. 調整時取下針棒護蓋上的孔塞，放鬆結合銷鎖緊螺絲上下移動針棒到適當位置。
LOOSEN THE SCREW OF NEEDLE BAR CLAMP AND ADJUST THE NEEDLE BAR TO GET PROPER HEIGHT.
E. 再鎖緊螺絲，調整針棒高度後必須確認針尖對正針板孔的中心。
AFTER ADJUSTMENTS,TIGHTEN THE SCREW OF NEEDLE BAR CLAMP AND MAKE SURE THE NEEDLES
ARE IN THE CENTER OF NEEDLE DROP HOLE OF NEEDLE PLATE.
12
1mm
0.5～
E
D
C
NEEDLE
DROP
HOLE
NEEDLE
PLUG SEAL
SCREW
LOOPER
結合銷
LEFT NEEDLE
孔塞}
鎖緊螺絲
結線鉤
左針
BAR
CLAMP
圖
圖
圖
SET
SCREW
ROCKER
ARM
LOOPER
6-3 安裝下結線鉤 INSTALLING LOOPER
F. 將結線鉤插入承座的孔內，柄部的螺絲槽對正鎖緊螺絲，確實將結
結線鉤
線鉤貼緊承座後鎖緊螺絲。
INSTERING LOOPER ALL THE WAY INTO LOOPER HOLDER AND
PLEASE MAKE SURE LOOPER IS FULLY FITTED INTO PROPER
POSITION,THEN TIGHTED SCREW (A).
圖 F
SET SCREW
GROOVE
柄部螺絲槽

Kingtex FT Series Specifications

General

Brand	Kingtex
Model	FT Series
Category	Sewing Machine
Language	English