Kingtex FT Series User Manual

0.5mm
SPREADER
SCREW
E.
1.0mm
WHEN NEEDLE BAR AT THE LOWEST POSITION. THE CLEARANCE
BETWEEN THE SURFACE OF TOP COVER THREAD GUIDE (A) AND
THE UNDERSURFACE OF TOP COVER THREAD EYELET (B) IS
1.0 mm. SET THE THREAD HOLE OF TOP COVER THREAD EYELET
ON THE CENTER LINE OF THE SLOT OF TOP COVER THREAD
GUIDE,THEN TIGHTEN SCREW.
16
安裝裝飾線導線板
裝飾線導線板的下端位於結線鉤上方 ，結線鉤擺動到最右
0.5mm
SETTING THE TOP CIVER THREAD GUIDE
D.
7-2
端時飾線必須輕輕掛在導線板上。
TOP COVER
1mm
THREAD GUIDE
AND HANGING LOOSELY ON THE TOP COVER THREAD GUIDE.
THE THREAD IS CAUGHT BY THREAD HOOKING PART PROPERLY.
SPREADER COMES TO THE EXTREME RIGHT,AND AT THIS POSITION,
OF THE TOP COVER THREAD GUIDE AND SPREADER AND WHEN
THESE MUST BE A CLEARANCE OF 0.5 mm BETWEEN THE BOTTOM
導線桿
導線板
導線板與導線桿中心約略重合，調整時可放鬆螺絲來調整。
針棒行進到下死點時，導線板與導線桿之間的間隙約為 ，
圖
結線鉤
螺絲
導線桿
導線板
TOP COVER
D
THREAD EYELET
E
TOP COVER
圖
THREAD GUIDE
TOP COVER
THREAD EYELET
(A)
(B)

Kingtex FT Series Specifications

General

Brand	Kingtex
Model	FT Series
Category	Sewing Machine
Language	English