Kioti CS2510H User Manual

7
-
17
MAINTENANCE
7
5. Apply a thin lm of clean oil onto the
O-ring of a new lter.
6. Tighten the lter rmly until it con-
tacts the mounting surface. Tighten
the lter a half turn further by hand.
7. Run the engine for a few minutes
and then stop it after installing a
new lter.
8. Check the uid level and add uid
to the specied level.
9. Make sure that the transmission
uid does not leak through the seal.

To prevent serious damage to
the hydraulic system, use only
a KIOTI genuine lter.

Do not operate the tractor im-
mediately after changing the
transmission fluid. Run the
engine at medium speed for a
few minutes to prevent dam-
age to the transmission.
IMPORTANT
To avoid personal injury:

Be sure to stop the engine
before changing the fluid or
replacing the lter.

Cool down the uid sufciently.
You can get burnt by hot uid.
CAUTION
Oil capacity
13 L (3.4 U.S.gal.)
(1) Gauge (2) Oil Filler Plug
(A) Oil level is acceptable within range
M46O705A
(1) Air Bleeding Plug

When adding the fluid, un-
screw the bleeding plug on
the left of the hydraulic cylin-
der. Other-wise, the fluid can
overow.
IMPORTANT
M46O715A
CS2510,2610-유럽,호주향-07.indd 17 2020-11-10 오전 9:08:04

Kioti CS2510H Specifications

General

Brand	Kioti
Model	CS2510H
Category	Tractor
Language	English