1. Park the vehicle on level ground
and apply the parking brake rmly.
2. Make sure that the fuel is sufcient
in the fuel tank. If necessary, fill
the fuel tank with fuel.
3.
Unscrew the bleeding bolt (1)
slightly and crank the engine.
Che
ck that air comes out of the
gap.
4. When air bubbles are not seen
any more in the drained fuel,
screw the bleeding bolt and try to
start the engine 2~3 times again.
5.
If the engine still cannot be start-
ed, unscrew the nozzle holder nuts
(9
) of the No. 1 and 3 cylinders
and crank the engine to check that
air comes out.
6. When air bubbles are not seen
any more in the drained fuel, tight-
en the nuts and start the engine.
7.
the engine.
To Next Page
Loading...
Need help?
General
