4
-14 DK90
INDEPENDENT PTO
The independent PTO mode is used for
normal PTO operations. It operates con-
tinuously at a constant speed, indepen-
dent of the transmission speed
selections. The PTO shaft turns in a
clockwise direction (as viewed from the
rear of the tractor).
GROUND SPEED PTO
The PTO speed will be proportional to
the tractor speed. The PTO shaft will
stop when the tractor is stopped. It is
important to note the PTO shaft will
rotate in the opposite direction when the
tractor is in reverse.
CLUTCH PEDAL
(1) Clutch Pedal
When the clutch pedal is fully
depressed, the clutch is disengaged.
Shift the main shift lever to the desired
speed and gradually release the clutch
pedal, then the clutch will become
engaged.
The clutch should be disengaged by
stepping on the pedal quickly, and en-
gaged by slowly releasing the pedal so
as not to damage the clutch plate.
S43O430A
The clutch pedal must be quick-
ly disengaged and be slowly en-
gaged.
Never operate the tractor with
your foot resting on the clutch
pedal. Doing so may contribute
to premature clutch wear.
IMPORTANT
To Next Page
Loading...
