Kirisun DR600 Service Manual

DR600 Service Manual
4. Function and Parameter Setting
4.1 Conventional Functions
Conventional DMR functions:
 Supports DMR dual slot mode
 Supports DMR private call, group calla and all call transfer
 Supports short Message, status message transfer
 Supports end to end voice and data encryption
 Supports GPS
 Supports interruption and monitor function
 Supports stun, activation, kill signaling transfer
 Supports IP connection
 Supports Standard AIS Interface
 Support Analog and Digital Mode
 Supports Pseudo Trunking
4.2 Parameter Setting
Repeater is set with default parameters when leaving the factory. Parameters such as operation frequency,
channel paramenters, scan and encryption may be changed according to different requirement by
users.Therefore, Kirisun specially designed programmable software CPSp, which is interface-friendly, easy
to operate and display-friendly, to realize the setting for repeater function parameters.
4.2.1 Parameters setting
Parameter settings steps are as follows
Step 1. Install the right version of the CPSp user programming software.
Step 2. Using RJ45 ethernet cable to connect the repeater with Ethernet port of computer through
HUB/switchboard.
Step 3. Make sure the repeater is powered on.
Step 4. Operate CPSp user programming software for the settings of related parameters.
The user can read parameter configuration through CPSp user programming software.
4.2.2 Install CPSp user programming software
Installation steps of CPSp user programming software:
28

Kirisun DR600 Specifications

General

Brand	Kirisun
Model	DR600
Category	Repeater
Language	English