KitchenAid 5KSM156 - Beater to Bowl Clearance

English
11

4
To Remove accessory: Repeat steps 1
and 2. Press accessory upward as far as
possible and turn to the left. Then pull
accessory from the beater shaft.
ASSEMBLING THE STAND MIXER
Beater to bowl clearance



1
Turn speed control to “O”. Unplug
Stand Mixer.
2
Lift motor head. Turn screw slightly






NOTE: 

side of the bowl. If the flat beater or the


the beater or wires on whip may wear.