KLS Martin Minicutter - Mains Connection

Instructions for Use
Electrosurgical Unit Minicutter
12 Revision 08
16
Mains fuses
T1.6 AH, 250V
17
Connection for mains cable
18
Type plate
19
Equipotential bonding connection
Connection for neutral electrode
Neutral electrode for HF currents connected to ground; not connected for NF currents
Symbol for the classification of the device (BF)
Unit is defibrillator-proof
Means: WARNING!
PLEASE READ INSTRUCTIONS FOR USE!
WARNING – HIGH-FREQUENCY CURRENTS
CAUTION, HIGH VOLTAGE!
4.3 Mains Connection
Before initial switching on of the unit, ensure that your grid complies with the voltage setting of the unit
indicated on the label (next to the power input). If the voltage ratings should not match, please contact our
Martin Service Center.
The device is available for the following voltage range:
• 100 – 240 VAC (50/60 Hz)
T1.6 AH, 250V