8.2 Impulse Response Loading
Third-party Impulse Responses can be loaded into the ENDGAME’s User Slots via the USB-C
connector. These Impulse Responses can then be accessed using the UA and UB positions on the
CAB IR rotary control.
To load your own choice of IRs into these User Slots, all you require is a Mac (running macOS
10.13 or later) or a PC (running Windows 10 or later) and a relevant cable to connect ENDGAME
to your computer.
Please follow this procedure to load Impulse Responses into the ENDGAME’s User Slots:
1. Connect the ENDGAME to your Mac or PC using a standard USB-C cable.
2. The ENDGAME should appear on your host device as a mass storage device (external drive
etc).
3. Simply drag and drop the required Impulse Response le into the relevant folder.
The folder structure denotes Left and Right within UA and UB. Drag and Drop either the
same Impulse Response le into both the Left and Right folders or use different Impulse
Responses for Left and Right if so desired.
4. When no Impulse Response exists in a folder, the ENDGAME will load the factory preset
Impulse Responses by default.
While the ENDGAME is a plug and play class compliant USB device, we highly recommend that
you unmount (Mac)/ Eject (Windows) the mass storage device/drive before unplugging it from
your computer. This will help to prevent any connection errors or data loss when reconnecting.
Notes: ENDGAME’s architecture allows for MONO .wav Impulse Response les specied up to a
maximum of 96 kHz / 500 ms. Any lower sample rate or length will be upscaled as part of the
convolution loading process.
Support for 44.1, 48, 88.2 and 96 kHz sample rates requires Firmware V2 (or later) to be installed.
WARNING: Do not load any other le standard other than PCM .wav IR les at 44.1, 48, 88.2 or 96
kHz into ENDGAME, as this may give unpredictable results.
To Next Page
Loading...
