8.3 Power Amp Mode
Power amps can make a fundamental difference to your tone. ENDGAME’s integrated Tube
Power Amp Simulator is designed to replicate the overall tonal characteristics of the most
common type of tube amps to give the “right” amount of sag and compression.
Simply push the POWER AMP MODE button on the right-hand side of the pedal to toggle
between the 3 Power Amp Models and Bypassed.
The colour of the front panel PWR AMP MODE LED pedal indicates what mode is selected:
PWR AMP MODE LED green
EL34 selected
PWR AMP MODE LED red
6L6 selected
PWR AMP MODE LED orange
KT88 selected
PWR AMP MODE LED Blank/unlit
Off/Bypass
Note: ENDGAME’s Tube Power Amp Simulator always comes before the Dual Cab Impulse
Response in the signal ow. For more information, see the
To Next Page
Loading...
