10.2 Aux Input (Bluetooth)
To activate Bluetooth® Pairing Mode and connect a device to stream audio to ENDGAME,
proceed as follows:
1. Press the BT PAIR button on the ENDGAME for approximately 4 seconds until the BT LINK
LED on the front panel ashes.
2. In your device’s Bluetooth® audio paring settings, choose “KMA ENDGAME” as the device.
The BT LINK LED will turn solid once a connection has been established.
Your device should now be able to stream Bluetooth audio through the relevant outputs of
the ENDGAME*.
3. Adjust the AUX MIX control on the top panel to adjust/blend the external audio level in
balance to ENDGAME’s signal.
For more information, see the
“Aux Mix” section.
Please ensure that your external device is providing sufcient level to the ENDGAME before
adjusting the control.
Note: An active paired Bluetooth® connection will override any analog device connected to the
AUX IN. To disconnect and unpair your Bluetooth device, push and hold the BT PAIR button until
the BT LINK LED is no longer illuminated.
As with all Bluetooth® devices, any audio connections using this connection method will add
latency/delay to the signal. This is of no consequence for static backing tracks, recorded music
and the like. However, for real-time audio signals that should be processed without latency, we
suggest that you use the regular analog AUX IN jack.
KMA Machines ENDGAME manual ⋅ firmware version V2 https://kma.specs-and-docs.online/kma_endgame_manual__English.htm
41 von 57 08.01.2025, 14:38
To Next Page
Loading...
