Knick Protos 34009(X) - Page 38

38
Protos 3400(X)
SW 3400-102: Loadable Parameter Sets
Parameter setting/System control/Parameter sets
Menu Display
Saving a parameter set on
SmartMedia card
To save a parameter set on
SmartMedia card
• Open parameter setting
• System control
• Open “Parameter sets” (Fig)
2 complete parameter sets (A, B) are
stored in the analyzer.
Up to 5 parameter sets can be loaded
to the SmartMedia card. To do so, a
parameter set (1, 2, 3, 4 or 5) of the
SmartMedia card is overwritten by the
device-internal parameter set A.
• Select parameter set from
SmartMedia card
Set A
SmartMedia card
Set 1
Set 2 Set 3
Parameter sets (Administrator)
Abort
For switchover see
“Function control matrix”
Parameter sets
Save parameter set
25.1°C
0.003mS/cm
Load parameter set
A,B (internal)
1,2 (card)
1,2,3 (card)
1,2,3.4 (card)
1,2,3,4,5 (card)
Parameter sets (Administrator)
Return
For switchover see
“Function control matrix”
Parameter sets
24.2°C
0.002mS/cm
1,2,3.4 (card)
Load parameter set
Save parameter set
Save parameter set (Administrator)
Abort
NOTE: Old parameter set
will be overwritten!
0.002mS/cm
Save to
3 (card)
2 (card)
B (internal)
4 (card)
5 (card)
1 (card)
Set B
(internal
only)
24.2°C