To Next PageTo Next Page
Need help?Do you have a question about the Knick Stratos MS A405 Series and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Power Supply | 24 V DC |
| Protection Class | IP 65 |
| Measurement Principle | Electrochemical |
| Measurement Parameter | Oxygen |
| Output | 4-20 mA |
| Housing Material | Stainless steel |
| Material | Stainless steel |
Manual activation and purpose of HOLD mode.
Process of calibrating the device.
Setting up the device for measurement tasks.
Describes signal behavior during HOLD and how to exit.
Settings for sensor type, measurement range, and solution.
Settings for the first current output.
Settings for alarm delay, sensocheck, and tempcheck.
Settings for the second current output.
Settings for relay functions (limit, alarm, wash).
How to select and configure the device type.
Selecting measuring mode and range.
How to configure and use sensor verification.
Setting the output current range and start/end points.
Setting the output current range and selecting the process variable.
Setting up linear, bilinear, or logarithmic curves for output.
Setting up bilinear output characteristics with vertex points.
Setting up logarithmic output characteristics.
Defining start and end values for logarithmic curves.
Configuring the time averaging filter for output.
Details on filter time constant and operation.
Configuring output behavior during error or HOLD states.
Setting output current for error messages, Sensoface, or HOLD.
Configuring the start and end values for current output.
Configuring alarm delay, sensor monitoring, and temperature probe monitoring.
Setting alarm delay and enabling/disabling Sensocheck/Tempcheck.
Choosing how temperature compensation is applied.
Details on linear, nLF, and NaCl compensation methods.
