Knick Stratos MS A405 Series - Operation; Measuring Mode Operation

17
Operation
Measuring Mode
After the operating voltage has been connected, the analyzer automatically goes to
“Measuring“ mode. To call the measuring mode from another operating mode (e.g.,
Diagnostics, Service): Hold meas key depressed (> 2 s).
Depending on the conguration, you can set various displays as standard display for
the measuring mode (see page20).
Note: By pressing the meas key in measuring mode you can view the displays for
approx. 60 sec.
Sensoface indicator
(sensor status)
Time
Mode indicator
(measuring)
Hold meas key
depressed
for calling the measuring
mode
(hitting the key once more
switches the display)
Display indicates
OUT1:
e.g., measured
value
Display indicates
OUT2:
e.g.,
temperature
enter key
NOTICE:
You must congure the analyzer for the respective measurement task.