24
Manual activation of HOLD mode, e.g., for sensor replacement.
The signal outputs behave as configured (e.g., last measured value, 21 mA)
pH adjustment / ORP adjustment / product calibration
Adjustment (WTR/AIR) / zero adjustment / prod. cal.
Adjustment with solution / cell factor input / prod. cal.
Adjustment of temperature probe
Configuration
See “Overview of Configuration” on next page.
Display of measured values for validation (simulators)
Current source, output 1
Current source, output 2
Relay test
Specifying access codes for operating modes
Selecting the device type
Reset to factory setting
(Access via
code, factory
setting:
5555)
Display of calibration data
Display of sensor data
Self test: RAM, ROM, EEPROM, module
100 events with date and time
Display of direct sensor values
Display of software version, model designation, serial no.
Pressing the menu key (down arrow) opens the selection menu.
Select the menu group using the left/right arrow keys.
Pressing enter opens a menu item. Press meas to return.
TAG display
after 60 s after 60 s
CLK display
Operating Modes / Functions
Measuring
mode
(main display
selectable)
To Next Page
Loading...
